{"id":1150,"date":"2024-07-01T09:56:00","date_gmt":"2024-07-01T09:56:00","guid":{"rendered":"http:\/\/robonza.com\/beetle\/?p=1150"},"modified":"2024-07-01T02:58:04","modified_gmt":"2024-07-01T02:58:04","slug":"installing-a-super-beetle-solutions-cut-off-switch","status":"publish","type":"post","link":"https:\/\/robonza.com\/beetle\/index.php\/2024\/07\/01\/installing-a-super-beetle-solutions-cut-off-switch\/","title":{"rendered":"Installing a Super Beetle Solutions Cut Off Switch"},"content":{"rendered":"\n

Months ago I installed a negative cut off switch from NAPA<\/a>. While it worked I never loved it, I had to remove the back seat to get to it and when I put on the new negative ground strap from Wolfsburg West it would not fit anymore. There was an ad on The Samba for product from Super Beetle Solutions that I had been eyeing since I got the beetle that looked nice. It is pricey at $120, so I went to NAPA to buy all the parts and make my own. You know what? It is a deal at $120 especially when you consider it includes all the parts to specific to the beetle. This is no cheap switch, it is hefty with a nice finish. <\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n

It was an hour or so to install because I have aftermarket rear seat kick panels. With stock it would be even less. <\/p>\n\n\n\n

The detailed instructions and Hot VW article<\/a> cover the install really well. I lined it up, checked for clearance and drilled a hole. <\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n
\"\"<\/figure>\n\n\n\n

Then you just tighten it up and check the figment. <\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n

Then you just attach the wires, although pro tip, put your beetle up on ramps before you disconnect the battery because you will be replacing the battery to starter wire.
<\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n
\"\"<\/figure>\n\n\n\n

All buttoned up and done with this super slick look. <\/p>\n\n\n\n

\"\"<\/figure>\n\n\n\n
\"\"<\/figure>\n\n\n\n




Parts: <\/p>\n\n\n\n